Step 1:
Cut Strip Flashing to required length
allowing for overlaps and corner mitres.
Using a string line guide fasten top edge of
flashing using suitable fasteners with a
minimum 10mm head. |
Step 2:
Where there is a requirement to fix the
material over roof docking. Securely fasten
one edge to the flat area first. Go around
and down on the corners. Stretch the
remaining edge over its entire length form
over the roof profiles, seal and fasten. |
Step 3:
Apply a generous bead as neutral cure
silicone sealant under edges. |
Step 4:
Finish off fastened edges with a bead of
sealant both top and bottom. Use the
provided metal strip to seal only
overlapping ends. |
New wider and Paintable
